Recent content by Turborookie83

It's looking about 45$ shipping ups ground, 25$ for the starter. Just let me know!

Still have it!! Not sure on shipping yet, from cleveland to Washington I think ups quoted around 400$ if I remember? Pretty much gathered what I think I need for the 430 swap for now. Pm me or let me know if anyone still wants the motor or pieces parts. Starter is new in the box- headers have...

ok, will have internet at new house in a day or two.. but looking for at least 500 for the longblock, after digging through 2k in reciepts its hard to go toomuch lower. Make an offer though, anything reasonable, or trades for stuff towards a BBB swap.

Hey, still have that 3.8 longblock, were you still interested?

Hey sorry guys! Moving/ finishing new house for a couple days! Found some other stuff i forgot i had, as always..

Heads are rebuilt, still have the 83 headers i heard they were the best factory B4 efi. Make an offer on anything you need, otherwise the stuff is basically scrap to me! Have a brand new starter also!

Anyone out there need any B4 engine parts etc.? I rebuilt the 3.8 in my 83 t-type and never fired it, decided to go with a 430 swap. Its a longblock right now, but i still have many acc. to it, except the turbo/carb/intake. If you need something ask, i'm willing to let everything go pretty...

Cleveland, Ohio. I read the post if under 150 posts not to list parts for sale? Should i try on the B4 black area or list in the parts for sale?

Not to piggyback, but if anyone esle needs a turbo or manifold etc. I am swapping an 83 t type to a big buick, and have a complete setup... i actually rebuilt the 3.8 and never fired it.. i have everything, let me know? Make an offer, i have pics if wanted? Marc

Possibly a little late.. did you get a good turbo? I have a 83 setup that i dont need anymore. I didnt know anyone was rebuilding these? I was looking for someone a year ago or so but had no luck for gaskets!

I'll have to dig up all the reciepts, but the pistons were stock replacements... i believe forged, stock crank and rods. Crank under .020 and rods .010, again i would have to check to be sure. Edelbrock cam, only one listed for the 3.8. Also new timing chain, double roller and oil pump rebuilt...

83 3.8 rebuilt new everything and new edelbrock cam, never started! Best offer takes it! Have receipts for headwork and all parts etc. All misc. parts for motor too..anything for a b4 black car have complete setup! A/C parts too. BOP TH350 with converter - 75$ obo Need to get rid of this stuff...

Went to a buick 430 so lots of v6 stuff left over! A/C compressors and 1 good condensor brackets etc. air cleaners...hot air and b4 black 3.8 rebuilt! Heads re-done new bearings/pistons everything w/ edelbrock cam! Never started! Has 83 turbo manifolds on it and 83 car/turbo intake...

I have 2 complete 2bbl motors to part out! 1983 3.8 - Ran well when pulled from an 83 El camino Anything you need! Brackets, pulleys, valve covers, Manifolds etc.! Shortblock still good!! 1983 TH-350 V6 only trans, shifts great and no slippage when pulled from the El Camino!! 1985...

Putting the timing cover back together and have read the tech articles at another buick forum about modding the timing cover. My directions that came with it dont match the color springs for pressures... i am sure someone has done this but i am unsure exactly what spring to use and how...