I kinda figured the whole GN crowd in this are probably wouldn't be that big considering how short the driving season is in Michigan.
I'd like to meet some people that can give some good pointers in person. Seems like you can only glean so much knowledge off of the boards. It would be nice to...
I saw this in the ad block up top last night.
VC-25 - 25psi Boost Activated Turbo, Centrifugal
Has anyone had any experience with their stuff?
It seems pretty cheap, but if you think about what goes into making a basic progressive controller it should be.
I know most people go with...
I was really looking for more of a, "I'm bored and stuck in the house project" than anything. But then I saw this in the ad slot here last night.
VC-25 - 25psi Boost Activated Turbo, Centrifugal
Progressive controller for $115... anyone have experience with it?
Are you guys the crew that (at least at that time) meets like every wednesday up until the cruise? The guy I talked to said there were likea dozen or so GN's there.
A couple years ago I met a guy at the Woodward Cruise that says there is a GN club that meets regularly then meets up at a restaurant on Woodward. Does anyone have any info on this?
Has anyone out there ever thought of, or built their own?
I've saw a lot of DIY non-progressive ideas. Basically a pump, a solenoid, and a pressure switch.
It doesn't seem like a very hard thing to accomplish at all. I just am not sure if its worth the time to figure it out, the trip to...
I don't see any from Michigan listed. A couple years back I saw one parked while I was driving down Woodward for the cruise. I rubbernecked it hard core and came within inches of rear ending whatever was in front of me. It was worth the scare though...
Only time I've ever saw one around here.
As with most of my stuff I bought a system from someone off the boards and installed it. It seems to run ok, but the psi it comes on at doesn't seem to change at all when i mess with the knob.
Its been awhile since I've played with it, but IIRC it comes on at a really low PSI no matter what...
Awhile back I bought a used mass air and a MAFT+ from someone on this board and I could never get it to work. The car would run fine with the jumper, but as soon as i plugged the translator in it would die out. This is all coming from memory...
What I was hoping to do was send them the...
Does anyone know how long the website has been dead for? Or if its ever coming back?
I have some questions and I've been away from the car for a while and now I can't get on their site. I sent a message to the store website and didn't get a reply.
Anyone know whats going on?
Thanks
OMG that is a sweet car. I wish ours looked that nice.
I'd almost be afraid to advertise my car for sale in the metro area. I get plenty of "after hours lookers" if you know what I mean when it sits in my driveway :(
Last night I walked through a local cruise in and saw a Catera that someone had stuffed a 7.0l in to. It was a Lingenfelter conversion...pretty bad ass though.