Recent content by Jake04

  1. J

    Starting issue

    So after digging some more, I took a look at my crank sensor and the middle part of the tab was broken, looks like that is where the magnet is and it's broke off. The sensor slides back and forth in the bracket and must have moved and broke off the middle tab. Must be my issue???
  2. J

    Starting issue

    Okay so TPS reads.38, took a test light to injector and (don't have a noid light) grounded test light to battery, test light stays on when key on and cranking, ohms across injector is over 10 so based on flow chart ecm is shot, is it normal for an ecm just to die during wot?
  3. J

    Starting issue

  4. J

    Starting issue

    What should the tps read with key on, thanks for the no start charts they will help.
  5. J

    Starting issue

    I did try the battery reset, will the tps show on my scan master even though the car won't run?
  6. J

    Starting issue

    How do I check cam sensor?
  7. J

    Starting issue

    Driving my 87 GN today, ran great all day, went to leave stop light and mashed the gas, it took off good then after about 2 seconds it just died. Cranks but will not restart, check engine light on and giving me a code 12 or 24, fuel pressure on gauge shows 40psi, sounds like pump kicks on...
  8. J

    Reverse

    Excellent info, I decided to send the entire tranny out for rebuild so I will ask the builder if he determined the actual cause was what I thought.
  9. J

    Reverse

    Ex c
  10. J

    Reverse

    Awesome info, THX
  11. J

    Reverse

    I stand corrected the convertor is stamped D6, it is the stock turbo and I plan on keeping it, I am assuming since it is stamped D6 someone has changed it??
  12. J

    Reverse

    It is still the factory D5, and does still have the solenoid hooked up so that says it is a lock up, just curious if an upgrade would make sense while the tranny is out, my goal is to get the car somewhere in the low 13's, but more of a Friday night cruiser than anything.
  13. J

    Reverse

    After reading this I realize this is a little more than just pulling the valve body, so I am sending the tranny out for rebuild, Now since I will have it out should I upgrade the converter, if so any recomendations? I have a close to stock 87 GN I am assiming it has the factory Non lockup in...
  14. J

    Reverse

  15. J

    Reverse

    When you get access from a computer could you send it, very much appreciated
Top