I do still have the regulator. PM me your phone number or email and I will send you a pic. This is the one I have:
http://www.titanmotorsports.com/515seefi1in6.html
Thanks,
Joe
5.3L iron block engine built and assembled by Jensen's Engine Technology in Nescopeck Pennsylvania. This engine is not ran, and is currently wrapped in shrink wrap in my garage on an engine stand. Specs are as follows:
5.3L iron block bored to standard LS1 bore (3.898")
Factory 5.3L crankshaft...
Still for sale. Repair was no fault of my own. No turbosaver. I am in Arizona for the week but can scan the repair receipt I have from precision and some pics as well.
Thanks,
Joe
This turbo was originally on my buick v6, so it has a 3-bolt .63AR hot side. Billet compressor wheel. The cover has a 4 inch inlet and a 2.5 inch outlet.
I ran this turbo for about 25 miles before the bearings went bad, and the compressor wheel touched down on the housing. I sent it back to...
TE44, walbro 340, and erson cam/lifters are SOLD!!
Thanks guys!
Still got tons of stuff left. I will make an updated list within the next few days.
Joe