XFI internal data logger install ?

[c&cgn]

Trying to setup the internal data logger today.

Anyone have any tips and tricks ? I have the wire that is supposed to plug into the XFI box. From what I understand, this is supposed to go to a switched power source ?

It didn't come with any instructions other than to say hook up to slot B19 (or whatever the correct one is ) on the ECM.

Any thoughts from anyone who has done it would be much appreciated.

Thanks.

 

[plumber]

http://www.turbobuick.com/forums/pe...218761-xfi-2-step-setup-logging-question.html

 

[HighPSI]

The wire is the PA Enable wire located at Pin B19 of the XFI. If you have a stand alone harness it's Pin "F" of the POWAD plug. This gets connected to switched power (usually the trans brake button). Once you have it attached go to the master dash (F9 shortcut) and watch PA Enable it should go from "0" to "1" when you activate the wire.
Once you have verified that it is wired correctly, you will need to set up the dashboard and realtime logging screens and then configure the internal datalogger.

If you purchased the system from us everything is pre-programed and you just need to attach the wire.

 

[c&cgn]

Thanks for the help, I got it working today.