which control arm and sway bar

[turbo 250]

need to buy upper/lower rear control arms and sway bar.what kind is best for set up.rpe engine stroker,400 trans w/brake 3,600 stall and 9" rearend.looking for good 60' .
looking at bmr fabrication,hr parts n stuff,metco and spohn with ball bearings.
car will be driven street and drag.fiberglass trunk lid,hood,bumper(front and rear)and no heat or a/c
thanks in advance for input

 

[DIAZ 87]

HRpartsNstuff "Your WWW performance parts supplier"

 

[jdpolzin]

For your application, just get all HR components.

 

[turbo 250]

ok guys,
i have the complete set up from hr stuff(paul) and going to install sway bar on the moser 9" and i see where the sway bar and housing has about 1/4 " between them. what do you think should be (i have installed the bolts,washers and bushings-spacers the way showed in book)

 

[jdpolzin]

I alked with Paul about my bar for my 9" and from what I gathered, as long as it clears, it's good.