onefastjackass
New Member
- Joined
- Oct 6, 2002
Ok Yesterday I just started playing with my other functions on my T+ with extender chip.
I set cell 12 to 7 which would be open loop idle,launch assist and lean cruise.
I then set cell 13 to lock the convertor at 1 which would be 49 mph.
Now I don't think that I set the spool fuel or shift light to anything.
I drove it and happened to notice that when blipping the throttle sitting still that the check engine light would come on.
I was not holding it down to build revs or boost just tapping the throttle.
As soon as I would let my foot off it would go out.I was in a hurry so I just disconnected the power wire to the ecm and reset it and didn't try it again.
Is this normal if so what is it signifying. Thanks Kevin
I set cell 12 to 7 which would be open loop idle,launch assist and lean cruise.
I then set cell 13 to lock the convertor at 1 which would be 49 mph.
Now I don't think that I set the spool fuel or shift light to anything.
I drove it and happened to notice that when blipping the throttle sitting still that the check engine light would come on.
I was not holding it down to build revs or boost just tapping the throttle.
As soon as I would let my foot off it would go out.I was in a hurry so I just disconnected the power wire to the ecm and reset it and didn't try it again.
Is this normal if so what is it signifying. Thanks Kevin