B Buick8688 New Member Joined Jan 22, 2010 Jul 17, 2011 #1 I have a few rust holes that need some attention in the left rear well and right rocker panel. Just wondering what gauge of sheet metal would be appropriate for this job? or what gauge of sheet metal is used for the skin of the car?
I have a few rust holes that need some attention in the left rear well and right rocker panel. Just wondering what gauge of sheet metal would be appropriate for this job? or what gauge of sheet metal is used for the skin of the car?
J JC3569 Member Joined Jul 25, 2009 Jul 17, 2011 #3 steel 16,18 or 20 i also cut pieces out of old hoods fenders ect.where u located in mass i also live in mass.
steel 16,18 or 20 i also cut pieces out of old hoods fenders ect.where u located in mass i also live in mass.
B Buick8688 New Member Joined Jan 22, 2010 Jul 24, 2011 #4 Thanks for the info I went to home depot and picked up some sheet metal there its 26 gauge. 16 gauge looked to thick. I live in spfld
Thanks for the info I went to home depot and picked up some sheet metal there its 26 gauge. 16 gauge looked to thick. I live in spfld
