I have purchased an mechanical water gauge (autometer) and am curious to know the best way to install it. My concern is that by this being an aftermarket guage with its own readout guage and sensor, I will have to remove the stock temp. sensor to install the autometer sensor. So, I am bypassing the factory (ECM) temperature monitoring system for the car. I would like the water temp. to be read by the computer as well as by my autometer guage.
1. Is there any means of monitoring both systems almost the same way as I have read people do for the their oil pressure guages? (By Adding a T fitting into the oil pressure sensor line)
2. Does the green tach wire under the hood near the alternator, attach to a connector? Mine is not connected to anything.
1. Is there any means of monitoring both systems almost the same way as I have read people do for the their oil pressure guages? (By Adding a T fitting into the oil pressure sensor line)
2. Does the green tach wire under the hood near the alternator, attach to a connector? Mine is not connected to anything.