good mornin ,i finally recieved my scanmaster,knock gauge.everything is wired up except the power wires,can someone tell me wich wires {colors under dash}to connect.i appreciate the help
thanks,one more ?i forgot to ask,my power wire for the boost gauge light i figure goes to the dimmer,what colr is that?so i dont have to tear anymore apart.
thanks,one more ?i forgot to ask,my power wire for the boost gauge light i figure goes to the dimmer,what colr is that?so i dont have to tear anymore apart.
There's an LPS terminal in the fuse box panel itself also for dash light add ons.
Both the scanmaster and knock gauge are low power devices you can use any of the IGN terminals to run them both on one 14, 16, or 18 gauge wire from the fuse box, fuse that wire near the fuse panel with a 5A inline fuse.
There are locking IGN terminals that fit the fuse panel with a pigtail you can go right to an inline fuse with available at NAPA in the Belden line usually on a rack on the shelf out in the store.
A search in general tech. can find out the exact part numbers, the connector locks right into the IGN slot in the fuse panel.
thanks,one more ?i forgot to ask,my power wire for the boost gauge light i figure goes to the dimmer,what colr is that?so i dont have to tear anymore apart.