needle fell off - can it fix

[rkreigh]

I have a very old autometer fuel pressure gauge with the eastern performance "isolator" kit to run the gauge inside the car.

a week ago the gauge needle was jumping around showing way low and way high and then promptly fell off. is there any way to get the gauge face off and replace the needle on the pin? doesn't looked like it's keyed, just very fine splines

next question, are the electrical fuel pressure gauges any good? I am thinking about redoing the gauges on the car but also thinking of selling the old buford. too many toys.

thanks for any advice!:biggrin:

 

[gossamer]

I am not sure how to get the bezel off to fix your needle, but I have the 0-100 psi electric fuel pressure gauge from Autometer and have had very good luck with it so far. It's been in the car for about a 1 1/2 years with no problems. The electric fuel pressure gauges are very expensive though, around $200.00