MAF translator Gen II

[Rowdy45466]

I have a MAF translator Gen II where to use/put the aux/window and Voltage trigger 4 pin?

Where and what do you use the 4 pin conector on the GEN II translator?

Voltage trigger

Also the aux or window switch.

Any help would be great. I also have the wide band kit.

 

[TurboBuRick]

I have a MAF translator Gen II where to use/put the aux/window and Voltage trigger 4 pin?

Where and what do you use the 4 pin conector on the GEN II translator?

Voltage trigger

Also the aux or window switch.

Any help would be great. I also have the wide band kit.

Those are optional functions. You don't need need them right now.

Do you have everything else hooked up and ready to go?

 

[Rowdy45466]

Every thing else is up and running. THere is a grey wire on the 10 pin/wire connector that is not used. I did get the car fired up and running. I also got some of the base line set.

 

[TurboBuRick]

Nice job!

Do you know about Full Throttle Tech websie?

Might get more response to your GEN II questions over there.

I don't see a grey wire in my directions. What pin # is it?

 

[Rowdy45466]

I got the MAF translator from Fullthrottle and I was over on their site to get some general parameters.

I'll have to go see what pin the gray wire is.

Rob