In the market for headers

[eric_1984ttype]

My drivers side manifold is cracked and I am looking to install some headers. I was looking at the "KB Headers" by GN1 that full throttle sells and the Stock Replacement type header that TA has recently came out with. I have a rjc downpipe already. Are there any pros or cons to either set?

 

[TR Custom Parts]

I sell the GN1 headers as well. Also run them on my GN. You need to run a downpipe made for use with headers that have the crossover that comes up into the motor compartment. Not sure if the RJC dp will work.

 

[eric_1984ttype]

I sell the GN1 headers as well. Also run them on my GN. You need to run a downpipe made for use with headers that have the crossover that comes up into the motor compartment. Not sure if the RJC dp will work.

Thanks for the reply. I know its been awhile since I posted this. Are there any other clearance issues I should be worried about with these headers? I sent an email off to GN1 to see if they know if they will fit with the RJC downpipe.