Hotchkis UCAs, B-body spindles/brakes, brake lines, breathers, Updated

[highpsi87]

Bought the UCAs new and used them for several years. The passenger side rear bushing shows signs of it getting warm (see pic) but still works fine. Need cleaned up, might have 3-4000 miles $240 shipped

2 high pressure wastegate actuators, one set up with push loc fitting and was on a 67. The other was on a 51. Both work as they should. Your choice...$65 shipped each

Jegs breather tank, like new. Used for mock up and possibly 10 miles, clean. $70 shipped

http://www.jegs.com/i/JEGS-Performa...0/10002/-1?parentProductId=760016#moreDetails

The B-body spindles have 1LE rotors on them with new (at the time) calipers. They have been sitting under the work bench for years as shown. Might have driven them 1-2000 miles. Stopped great, handled great. Still have billet 17" Centerline "Hammer" wheels/tires with the correct offset if someone was interested. Make a reasonable offer...

The Russell brake lines are new...bought the kit for the rear line. It comes with everything minus the rear line. $40 shipped

Allstar breather is new, only used for mockup. $45 shipped

I purchased the Autometer guage cup for a mechanical guage and don't need the cup for the electrical guage (shown). Comes complete but I repeat, the part # is for a mechanical guage and the electrical guage cup is included. 2 5/8 guage...$20 shipped

Strange Hypercoils...10" 125 lb...used only for mock up...$80 plus shipping

 

[liquidh8]

Are the a arms for the b body spindles or can I run them with stock spindles?

 

[highpsi87]

I used them with the stock spindles and I think I used them with the B body spindles too...It was some time ago.

 

[highpsi87]

ttt

 

[highpsi87]

Anyone local want the B-body spindles...I want them gone!

 

[highpsi87]

UCAs sold...make offers on the rest.

 

[highpsi87]

Russell brake lines sold...