Fan coolant sensor help

jburnsinnj

Member
Jan 4, 2006
39
0
6
118
I am rep;acing all the sensors on my 87 GN. I cannot figure out how to remove the fan coolant sensor connector. I do not want to break it so can anyone tell me how to release it from the sensor? Thare appears to be a metal tab on the side which I tried pulling and pushing but no luck. The plastic connector rotates but will not release.
Here is a photo of the densor and it's location in the top of the l;ower manifold. Thanks for any assistance.
 

Attachments

grass doctor

Active Member
Sep 21, 2018
630
237
43
44
saint augustine fl
its a circular plug push in on both sides of the thicker black tabs( pinch it , ) and it comes off, its a lot like the the ac plug on the drier (low pressure switch)
 

ScottHeidinger

Active Member
May 2, 2015
615
91
28
50
northeast Florida
Looking at the plug for the sensor you can see 2 raised areas where you want to put your fingers and squeeze. While you have them compressed with your fingers pull straight up.


Sent from my iPhone using Tapatalk
 
Top Bottom