Driveshaft length?

[Whitettype86]

Guys, I need to know what the driveshaft length is yoke to yoke
on are regals? I sold my 3in Aluminium driveshaft and looking to get a 3.5 to 4in driveshaft.

 

[Reaper]

will, geez are you even to the point where you need one.. if you still pushing the car dont you just need a few guys to help

 

[Whitettype86]

I guess I could use your help moving the car back and fourth uh
The transmission is on its way and need to get that done and then I need to pay Nick for the motor and the car should be ready by Nov or Dec. Hopefully

 

[Whitettype86]

Anybody? TTT

 

[Reaper]

Will call me!

 

[bryguy]

NO OFFENSE

Have U ever heard of a !@%$#&* tape measure ????

 

[Whitettype86]

Well, I have a tape measure but I dont have a transmision in the car nor a motor so what do u do then?

I don't have a stock driveshaft to measure just need some help from u guys

 

[salvageV6]

Still got that Dynotech here. 3.5" Alum. MMX technology.

I can measure it tomorrow for ya.

I even know somebody with a camera now and can get those pics.

Good for 1200 hp.

 

[NASSTY]

From the tip of the front yoke to the center of the rear u-joint I measured 57"

 

[salvageV6]

These are from my 3.5" Dynomite Dynotech one.

57.5" tip of yoke to end of back yoke. About 56.5" from tip of front yoke to center of back U joint.

51" from center to center of both spicer U joints.

47.5" from the outer edge of the welds for the tubes into each yoke.

Yeah I know most of the measurements are useless.

 

[salvageV6]

Dynotech 3.5" driveshift fit like a glove in the GN.

Metco Loop didn't fit for $#&* needed a couple of washers for spacers or it would hit the floorpan.

Fit well with the large 3.5" driveshaft however for clearance.

Now I can sell the other one, since it won't fit with dual exhaust anywhere near the stock driveshaft like on the WE4.

 

[Whitettype86]

Thanks, 2NASSTYBUICKS and salvageV6 for the measurements.


salvageV6 what duel exhaust system do u have? Do u have adjustable upper control arms with your setup?