Body off frame.

[airborne_rex]

I'm pulling my engine and trans out to clean up some leaks and replace the fuel and brake lines as well and was thinking if it's not too hard taking the body off the frame and getting some rust repair work done to it as well. Is there anyone in the Garland/Dallas area that has experience with this task? I'd love some tips and any knowledge before I decide to take on this challenge.

 

[charlief1]

There's a good post in the how to section. One thing I can warn you about is don't use an impact on the body blots. Loosen them with a ratchet first, then use the impact.