K KWIKR 1 Active Member Joined May 25, 2001 Oct 10, 2009 #1 can a K1 Rod set up to accept a .927 pin be machined to accept a .940" wrist pin ? thanks .
K KWIKR 1 Active Member Joined May 25, 2001 Oct 10, 2009 #2 I just found out there was a misprint on the dia of the wrist pin on the listed piston . in fact it is a .927" pin . thanks .
I just found out there was a misprint on the dia of the wrist pin on the listed piston . in fact it is a .927" pin . thanks .