109 Long block with lots of rebuild parts

[Eric Stauch]

Parting with my '87 GN motor. It is a true 109 that I drove into my shop. It had a small tapping sound in the bottom end and weak oil pressure. After pulling the oil pan and inspection the bearings it had two real loose rod bearings. Crank looks fine may polish worst case .010 and rods can be resized no problem. The cylinders are on std. and look good just needs a hone. again this motor was running and performing great. I am also including a lot of rebuild parts: new main and rod bearings on std., new rings on std. they are the correct vin 7 rings. new full gasket set, new comp springs locks and retainers, new timing set, new oil pump and brand new timing cover with the updated front install seal. let me know if you want different pictures or have questions. Im looking for $1000 for this I think its more than worth it with the new parts. Im willing to ship it if your willing to pay for it! but keep in mind shipping is going to be high! a few hundred bucks I imagine so if your not prepared to pay that for shipping then please dont waste my time getting a quote. also if its not a local deal and paypal is going to be used then we will have to work out something on the fee. thanks, Eric.

PICTURES!

http://i628.photobucket.com/albums/uu9/thenasty87/photo-5_zpsc5efde81.jpg
http://i628.photobucket.com/albums/uu9/thenasty87/photo-4_zps343fe655.jpg
http://i628.photobucket.com/albums/uu9/thenasty87/photo-3_zps920946be.jpg
http://i628.photobucket.com/albums/uu9/thenasty87/photo-2_zps898a5ee3.jpg
http://i628.photobucket.com/albums/uu9/thenasty87/photo-1_zpse6f5c0ac.jpg
http://i628.photobucket.com/albums/uu9/thenasty87/photo_zps262380d5.jpg