Search results

Hi everyone, still looking for a 7 pin power seat switch if anyone has one.

If you take a look at this thread https://www.turbobuick.com/threads/correct-name-for-this-part.465206/ he has a pic of blower. Notice the purple wire with connector ? it appears to be connected to blower frame.

Thanks. I will check autozone but I have yet to find one that has the right connectors for a c68. The c60 only has one spade connector

I believe my blower motor in my 86 GN is squeaking . Usually gets better or disappears after running for awhile. I have the electronic controls which I believe uses a different blower motor than the manual C60 controls. Are the bearing on these blower motors replaceable and if not where can...

I bought this MAF and it worked great. https://www.ebay.ca/itm/292825542841?euid=null&bu=45002347294&cp=1&sojTags=bu=bu

I second this. Great car covers. Don't go cheap. The cheap ones will scratch your car.

What did you use to attach it to dash ?

thanks everyone. I ordered 51036

Is the correct WIx Filter part # 51040 ? This has anti drain back correct ?

so you are saying do not put an AC Delco PF52 filter on my car ?

I am not sure on the brand as they came with the car. Previous owner put them on

Doing my first oil change A quick search shows many recommend the AC PF52 . I have my 86 GN configured in Amazon. When I search that filter on amazon it says "does not fit my car" ? If I search PF 47F it says it does fit my car.

This seems to be a very common problem with replacement seals. On my 87 the seals had been replaced. The doors were hard to shut and they leaked. I found it was somewhat better if I shut the door with the windows down and then put them up after but they still leaked. You wouldn't think it would...

Not sure how that would run with key tuned off. Fan for Rad yes but not AC/Heater blower. Has any of the wiring been changed ?

Are you sure its not your tires causing the issue with contours in the road ?

ok thanks. I will try replacing the flasher. If I stick my head down low i can barely hear the click

All my turn signals work. When engaged I see the light on the dash flashing as it should but I don't hear any clicking . Signal disengages as it should when wheel goes back to center. What produces the turn signal clicking noise ? Is this the flasher ?

Thanks everyone for all the replies. Sounds like spool fool is the way to go. Kirban mentioned fiberglass squeaks against bumper. Anyone have this issue ?

I saw an older video (2012) from Kirbans saying they don't recommend fiberglass bumper fillers and don't sell them. I also have seen recent videos on spool fools fiberglass bumper fillers and they look very nice. Any opinions ?

Thanks guys