Search results

  1. L

    Anyone try these adj upper arms?

    Thinking about getting a set. http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=33583&item=2450952694
  3. L

    Powder coating the lower intake?

    If I powder coat it flat black.....that should help dissipate the heat ....... right? My intake is nasty even after a glassbead. I have the powder coat kit and powder so.........
  4. L

    Good deal on gray valve stem caps

    http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=6763&item=2428507663
  5. L

    Turbonetics Down Pipe

    I picked up a nice used 2 1/2 ceramic coated down pipe and have a question. It is for an external w/g-delta gate. Anyway,the small pipe that the delta gate attaches to does not loop back to the down pipe. If a d/g is installed,is it just going to "blow off" into the engine compartment? The...
  6. L

    McCord head gaskets??? Anyone use them??

    Good/Bad? Got a part number? Thanks.
  7. L

    Need part # for fluke egt meter

    What are you guys using? I also need the probe kit # as well. Thanks
  8. L

    Installing new bearings with motor in car. Ever run into this?

    I started out doing a rear main seal and when I dropped the rear cap,bearings didn't look so good. Appear to be water damaged. 60k on motor. Anyway,I took all of the mains out and to my suprise,numbers 1 and 3 are .001 and 2 and 4 are std. Ever run across this. I know why this was done just...
  9. L

    Takes a while to shift into 4th

    Here's the deal: If I put my car into OD,it stays in drive(3rd) for a long time before it shifts into 4th. If I get out onto the highway,in OD,it takes about 2 mins,at 60 to 65, before it shifts. :confused: Everything else is fine with it,UNTIL.......I turn the A/C on. Then all new...
Top