Search results

signal voltage high does anyone know of someone who can repair the ECM it is a Buick motorsports version of the stock 87 buick turbo unit thanks steve

Fore sale 12 tico racing engines push rods 9.500 length .080 wall appear new 6 stainless 1.62" exhaust valves and 6 titanium 2.08" intake valves used complete rev kit minus either left or right block ( note 2 are the same) $ 50.oo plus $ 14.00 frt Steve 702-564-3236

New Turbo parts for sale Garrett pn # 408694-5001 cold side 91mm hot side 88mm see pictures any half reasonable offer accepted plus freight

PN 408694-5001 cold side 92mm 73mm approx hot side 87mm 77mm approx. Would this turbo be of any use to the buick group

why do cometic head gaskets have such a small hole on the upper water jackets as compared to Fel pros steve

I was wondering what a safe A/F ratio for a stage II buick runing 16# of boost for more than !/4 mile say 45 t0 60 second bursts ( road racing) Steve

I have 2 Kinsler s-2 manifolds for sale and 1 set of stainless fuel rails I would prefer to keep then in the turbobuick group rather than sell them on ebay I am not sure if the pictures down loaded or not If interested email me at csrowan@cox.net or call 702-564-3236

do you still have the plenum and Kinsler injection for sale thanks Steve

what is the differance between the 3 and 4 wire crank sensors thanks steve

The turbo I have is a Garrett TV 71 ? It has a 102mm comp wheel and a 94mm exhaust wheel it has 4 bolt split exhaust entry I will need a V band on both intake and exhaust sides. This turbo is vintage 1986 so obviously a lot has changed. I would appreciate any suggestions. thanks Steve

I am looking for someone who repairs buick ignition modules it is a BMS unit but the problem is with the abc impulses to the coil witch is similar to the stock GN. I am also looking for a offcenter indy style plenam thanks Steve

I went out to start the race car and nothing. FI is pulsing and no spark. A. cam sensor voltage varies between 3 to 4.3 volts when cranking B. crank sensor voltage varies between 2 and 3 volts when cranking C. 12 .5 volts to the coil pak D. jumping A to P B to P and C to P there is spark E...

on ebay there is a new never fired S-2 twin turbo built by Mclaren for the 1983 Buick Indy pace car. I guess it was a spare motor I thought someone might be interested Steve

what gas do you recomend on a stage II for 14 to 17 lbs of boost (2.1 Bar absolute) 0r 62 in. Mercury Has anyone run VP motorsport 109 oxegenated fuel Thanks Steve

I have a never used Garrett turbo and was wondering what it could be used on A. 408696-5001 JE 0101 A/R 1.39 B. EX 88mm wheel cold 92mm wheel C. 4 bolt exhaust

looking for 9.75" (approx) Buick flywheel ste up for 7-1/4 " clutch Thanks steve

Does anyone have a current telephone number for George Montgomery Thanks Steve

I am looking for parts for a tv 71 turbo a.Turbine wheel 94mm 76 trim 11 blade, stub shaft is tri lobed b. Compressor wheel 102mm 52 trim 7+7 blade tri lobed bore c. TV 71 pn# 46618-52X d Mid 80's vintageThanks steve

I am looking for anyone who may have information on where the 3.0 ltr turbo IMSA motors The motors were built by McClaren in detroit Buick got rid of the motors in the early 90's. The person who sold them was named Roger Drendruzina sp?. I am looking for some pumps and pulleys. thanks steve...