Search results

Hi all, I am a member here since I am using a GN tank to feed an EFI'ed BBO 455 in my Olds Cutlass. My question is if anyone knows of an aftermarket source for GN tanks that have the correct plastic baffle. I really need a new tank. The one I have in the Cultass had sat open for quite some time...

Anyone know a good source with a good selection of drive and driven gears? I need to get a 13 tooth drive and a 31 tooth driven gear for a '78 Cutlass Salon into which I put a rebuilt KZF 200-4R (one of my other cars). I have a 3.08:1 geared posi rear so the speedometer reads way low. This trans...

Hi all, long time no post. I have my EFI Cutlass about ready to go and I am installing the new fuel sender/pump assembly in the modified Buick tank. I need to find a source for the mating electrical connector to wire the whole thing up like a stock turbo Buick. Does anyone have a source for the...

I am experiencing bad wheel hop on my '88 H/O when power braking or launching hard (tires breaking loose). WTF? I have never experienced this before on a coil sprung 4-link rear axle. The rear setup is stock (including the F41 anti-sway bar) except for boxing the lower and upper control arms...

I need to replace the driver's side axle in the '87 442 rear I have in my '88 H/O. It has a slightly bent axle flange evident when the car is on a lift and the car is run in gear (flange has a wobble to it). I originally got the rear out of a roll over wrecked '87 442. We didn't know it at the...

I need the fuel pickup/sender assembly. Fuel pump need not be included. This will be for an EFI'ed big block application. I have cash!! :D TIA,

I figure y'all are the best source of info on what I want to do, so here I am. I hope that I am not being disrespectful of the Turbo Buick forums by coming in and asking an EFI gas tank question for an Olds Cutlass (see sig below). Is there a source for new/used Buick tanks that I could use...