Recent content by Walt Skarb

intercooler bracket,drivers side. Center of bracket bolts to intercooler, ends to engine.

Have an 87 t-type with 200r4 transmission (brf). I have no 2nd gear, engine just rev.. All other gears seem ok . Tv pressures are taken with engine idle at 1200 rpm and psi readings are with no tv and full tv. P 60 150 r 100 270 n 60 160 od 60 160 d 60...

check for an exhaust leak at exhaust header . I had an exhaust leak at header and it drove me crazy. Sounded like bad lifter or bearing.

I have a tta that I purchased new and I recently pulled the pan to replace the rear seal. The side seal were rtv not the normal side seals. Is this common on the tta. I also noticed that the depth of the side seal groove's varied by .020" and made installing the side seal difficult. ( car has...

I had to replace two of them. On mine the horn started blowing in my garage at three am in the morning. I'm not at my home right now or I would give you the part number.

Go to the help section at napa or autozone and you should find a new one there. Should cost about $10.00. I think its called turn signal cancell.

tom money sent via paypal walt

" y " bracket for a/c and alt $30.00 shipped (2209) will Take one if still available. Need payment info ? Paypal ?

engine ticking niose Thanks for the information. Something else to c/o. Today the ticking is getting louder and seems to be galoping at times. Noise disappears as rpm are increased. Stethoscope seems to indicate noise is coming from topside although I can't pinpoint it. Plan on pulling...

I have a ticking noise coming from around #1 cylinder. I have a flat tappet Comp cam with comp lifters. Engine has about 3000 miles since rebuild and runs fine. clicking noise disappears when injector for #1 cylinder is disconnected and also when #1 plug wire is pulled. Pushrods, rocker arm...

84 gn I own a 84 gn and have owned it since Feb. 1984, purchased new. Great car, receive complements all the time. Car was a daily driver for twenty years and the seats are in perfect condition. I also own a 87 "T" and turbo Trans-Am. If I had to give any of them up, the 84 would be the last...

sent a pm on tensioner

When the rear end clutches stick the rear of the car will hop all over the place. Replace fluid with SAE 80w-90 GL-5 and add 4 0z. bottle of GM additive 1052358 (a Must). This should solve your problem.

Change the rear end fluid and make sure the gm additive is added

Can anyone identify the ford injectors I have ? 9F593 on one side and F7PU-A4A on the other side. Injector has Black top section with a silver lower.