Recent content by sixftseven

Do you still have the shortblock for sale?

pm sent

5 disc billit converter for the 200r4 with 0 pump and a 3200 stall. I used it very little, I went to a nonlockup. $550 shipped

Vigilante 9.5" Billet 5 disc lockup converter for 200r4 about a year old barly used $600. I also have a gn2 from Full Throttle $150.

Vigilante 9.5 5 Disc lockup converter for 200r-4, I bought it brand new year ago. It has 5 passes on its selling it for $700.00. I decided to go with a non lock up. I also have a Gn2 for sale for $175.00.

can you post some good pics of them?

is there any difference between the 86 and 87 winshield bezels? What kind of condition are they in?

need a 3 piece windshield bezel for 87 grandnational.

The Engine had no oil pressure he had the turbo saver installed wrong. Where does your engine leak oil at?

Who's the number one engine builder tuner on the east coast. I just recently had my engine built by wildcat performance and its leaking oil from the valve cover and rear main seal I think. Mike built the engine 3 times and its leaking oil. Its also picking up false knock at 18lbs of boost 21deg...

It seem like you offered a pretty good pice but I would go any higher. The market has cost the prices to soften up on these car quite a bit. Its some killer deals out there. I've seen some lower mileage gn's under 40k go for that price.

Yea I would start with a new factory ac delco o2 sensor and find your vac leak. Start looking for the vac leak by unplugging all your vac lines from the vac block on top of the throttle body and cap each vac port off. Look at your blm and they should go down to around 128. Plug one line back up...

Thanks for the reply. Is it really loud?

I'm trying to decide what exhaust to buy, I'm very interested in GN1 is anyone running this exhaust? Is there any drone noise or hitting anything under the car. thanks

Yea it could be the knock sensor but I just dont know if that would cause the car to cut off. I'm aware of the over tighting and I also took it out and wrap some teflon tape around the bottom to desensortize it but no change. I have also turned the alky off and took the rod off and made a easy...