Recent content by robs0574

i'll turn it up and will report back thanks

anyone?

Hey all i installed a few parts onto my car and am having some problems. The scanmaster #'s look good im running 15lbs boost with the alky turned off. The car gets up to boost ok with no tire spin(lack of power) and holds boost ok. the parts i installed are as followes 61 bb turbo, 42.5 lb...

I tried but can't seem to get a hold of him.

Hi all, im looking for someone who knows these cars and how to tune them. Im located in the milton/janesville area. Does anyone know of anyone in the area who could help. Thanks Rob

Thanks i have a T.H. style downpipe on the way i'll let you know how it works!

Tanks for all the help. Would i be able to get a different down pipe to fix the problem?

Ill go and check it, if it is smaller where do i go from here?

I can get more than5lbs of boost it just isnt spooling up quick ill get my max boost just a little bit before shift.

pro torque 3200 9.5" from jack at cottons

I do have a 93 chip ill try tuning without the alky. I am also still running the stock downpipe looking for a T.H. style. I do recall reading about porting out the stock downpipe how do i go about doing this, IS there anything else i can do to get this to move better off the line?

Will it be ok if i have a chip tuned for the alky to turn it off and tune it?

I took the car out for a drive and it stumbles to shift and stumbles in second and third gear here are some of my scanmaster #'s AF .06 L8 31 BAT 13.5 Int 128 Bl 125 Clt 187 I Dont have my 160' thermostat yet Ats 100 RPM 1100 IDLE TPS .42 IDLE 4.64 WOT iac 07 CC 203 Warm after run...

I have been looking for a T.H. style downpipe kinda hard to get any idea where to get one. There don't seem to be any vac leaks. My chip is for my car/combo i had eric burn it for me last week and im running razors progressive alky kit using denatured alcohol. Ill try to get scanmaster #'s out today

The exhaust is 2.5 in aftermarket cat back! I didn't notice any leaks and it is a stock downpipe. I will try to get into messing with tt chip later today, should i take fuel away/add fuel? Timing?