Search results

i'll turn it up and will report back thanks

anyone?

Hey all i installed a few parts onto my car and am having some problems. The scanmaster #'s look good im running 15lbs boost with the alky turned off. The car gets up to boost ok with no tire spin(lack of power) and holds boost ok. the parts i installed are as followes 61 bb turbo, 42.5 lb...

I tried but can't seem to get a hold of him.

Hi all, im looking for someone who knows these cars and how to tune them. Im located in the milton/janesville area. Does anyone know of anyone in the area who could help. Thanks Rob

Thanks i have a T.H. style downpipe on the way i'll let you know how it works!

Tanks for all the help. Would i be able to get a different down pipe to fix the problem?

Ill go and check it, if it is smaller where do i go from here?

I can get more than5lbs of boost it just isnt spooling up quick ill get my max boost just a little bit before shift.

pro torque 3200 9.5" from jack at cottons

I do have a 93 chip ill try tuning without the alky. I am also still running the stock downpipe looking for a T.H. style. I do recall reading about porting out the stock downpipe how do i go about doing this, IS there anything else i can do to get this to move better off the line?

Will it be ok if i have a chip tuned for the alky to turn it off and tune it?

I took the car out for a drive and it stumbles to shift and stumbles in second and third gear here are some of my scanmaster #'s AF .06 L8 31 BAT 13.5 Int 128 Bl 125 Clt 187 I Dont have my 160' thermostat yet Ats 100 RPM 1100 IDLE TPS .42 IDLE 4.64 WOT iac 07 CC 203 Warm after run...

I have been looking for a T.H. style downpipe kinda hard to get any idea where to get one. There don't seem to be any vac leaks. My chip is for my car/combo i had eric burn it for me last week and im running razors progressive alky kit using denatured alcohol. Ill try to get scanmaster #'s out today

The exhaust is 2.5 in aftermarket cat back! I didn't notice any leaks and it is a stock downpipe. I will try to get into messing with tt chip later today, should i take fuel away/add fuel? Timing?

Hey all just looking for some help/input. I just installed an alky kit, cpt61 bb turbo, 42.5lb injectors, fuel pump, fuel pressure reg, tt chip, scanmaster 2.1 and a ptc 9.5 in conv. The car doesn't have any low end power and when i get into the turbo at 15-18lbs it seems to have a flat/dead...

x2 i agree you cant force them out let the court do it or you will be looking at a lawsuit! i run into this problem too it sucks

Hey just looking for some help tuning and installing some aftermarket parts on my 87 gn im located in janesville wi thanks

Just looking for someone in the Janesville Wi area to help me tune and install some new go fast parts any suggestions??? thanks rob

i im kinda new to this site,buicks and transmissions! Im just wondering what the different stalls are and how they affect your car thanks rob