Recent content by QWK GN

I have a couple of totes full of die casts, I know I have 1 or 2 of those.

finally got around to swapping out the switch. All is good now. I opened the old switch and it was gummed up. I'll clean and relube it and put in my stash of parts.

Thanks for the info. I already order a new switch from Advance. When I get the old one out ,I'll relube it and see what happens.

After testing power at C209 and the switch, I was able to get the light to work sometimes. After using test light to verify power at switch ,It seems the brake switch has a intermittent short. I've owned this car since new and Just don't see it as the old car it is. I'll be picking up a new...

My 3rd brake light is out, I checked the power at the blue wire in the connector in trunk and my test light barely lights up. Checked power at brake switch and full power at the blue wire.. I know there is another connector around the fuse box that the blue wire from the brake switch goes to...

I spoke to Bweavy and he told me his headers are 100% made in the USA not reworked in the USA. His headers are port matched and install with out any blunt force tools needed. So now I know where I'll be buying my new set. Thanks, John O

I would like to get the headers from TA,but they are out of my price range. I just wanted to know how well the ones from g-body fit,how complete is the kit. Thanks. John O

I'm looking for any input about the stainless headers being sold by G Body.com. I really need to get new headers and I don't want chinese junk. Thanks, John O

count me in.:rolleyes:

I'm in Count me in too. John O-86GN

Need a car fax I need a car fax on a used car my sister bought. vin- 1GNDT13W912222614 email- racerx86@ netzero.net Thank you , John O

Is there any charts for identifying fuel injectors? I'm trying to ID these injectors--thin white body, D 280 155 868 on the side, I think they're Mototron 60# but I'm not sure. Thanks, John O

How complete is the included hardware? are the two studs the the drivers side included. I really hate when you big $ for a complete kit only to find out it's not. thanks- John O

Are these headers any good,any problems with how they fit, and are the coated one's better than the stainless version.I really need some new headers as my stock ones have cracked again and I want somthing better. I seen the Poston headers and was'nt impressed. Thank- John O

Scott, Thanks for the reply,I just got a new actuator so I'll set that first, and make some passes at the late night drag strip to fine tune the turn on point and boost level on the BSTC and take a few #'s off for 3rd. Thank-John O