Recent content by paintitblack

  1. P

    aluminum drums, lower intakes, balancers, NOS front fillers

    Interested in the rockers. Are they in good shape with no abnormal wear?
  2. P

    Can't get the boost down!

    No I have since changed it back to the correct routing, and the downpipe and gate was preassembled from GN1. Not sure what you mean by running it tuner style?
  3. P

    Can't get the boost down!

    I did, it's not.
  4. P

    Can't get the boost down!

    I will check this weekend. I would say it's probably an inch or bigger.
  5. P

    Can't get the boost down!

    Thanks for responding. I have done that and it's still climbing. The deltagate was backed off all the way. The GN1 gate doesn't have a tension screw (the new one I have on now) but I did run it with the top port open to atmosphere. Both wastegates are good and functional but wont control boost...
  6. P

    Can't get the boost down!

    I can't seem to lower the boost. Let me start from the beginning and tell you what I have done because I am stumped. After the car sat for 8 years I bought a complete intercooled motor from a friend and got the car running. It had hooker headers, 3in downpipe with a deltagate, turbonetics boost...
  7. P

    Problems please help

    Thats what I figured. Would you or anyone else have anymore specifics. Do I need to run power to every single thing or should it be to one or two wires? I'm sure someone has delt with this before. I'm not the only one to do this swap. Any help would greatly appriciated. I just don't want make a...
  8. P

    Problems please help

    That wire is ran and connected and has power all the way to the ecm
  9. P

    Problems please help

    I also ran a jumper wire to the fuel pump test lead and the pump primed the lines. I know the ecm controls the pump. I'm wondering if the 85 fuse box don't distribute the power correctly to the 87 harness? I'm hoping we can figure this out without pulling out the entire harness and going thru...
  10. P

    Problems please help

    Yes i'm using an 87 harness, ecm, and the chip was burnt by turbo tweak. I have the 85 calpack in cause i didn't have an 87 one and eric at TT said they were the same. The ecm is a reman from special additions and never used. I check the ignition power at the pin, didn't probe the wire. The...
  11. P

    Problems please help

    I need help cuz i'm pulling my hair out. I've done a complete 86/87 swap into my 85 T. I've got everything done and ready to fire it up but I have no power to anything on the motor and the service engine soon light and the fuel pump dont come on. Everything else works lights, windows...
  12. P

    Cowl panel weatherstripping

    Hi guys, I'm looking for the weatherstripping seal that goes at the top of the hood on the cowl panel. I remember seeing someone selling them new online but can't seem to find them now, or remember who had them. I did a a/c delete a long time ago before they started to make the cowl delete...
  13. P

    Jegs or Summit

    +1:) Summit does have some more of the off the wall stuff (not vehicle related, t-shirts, memoribilia) and does sell stock replacement parts where as Jegs don't. For me it's a 50/50 unless I need it today, then I usually drive to Jegs. Perks of living close to a national performance parts chain:D
  14. P

    86/87 Engine Harness

    Sent u a pm.
  15. P

    86/87 Engine Harness

    Sent u a pm, didn't get a e-mail.
Top