Does something need to be turned on in .bin for the Scanmaster to work?
Mine powers on, then goes blank.
I have a diode running to ground, the resistor going to +12v, and they both connect to the wire Scanmaster signal wire, that runs to D2 on the ECM....I suck at reading schematics, but...
Who makes a good MAFless CAI? My temp. air cleaner setup is pretty crappy looking, lol.
https://www.dropbox.com/s/jnspm1hx967zguw/IMG_20150519_135004.jpg?dl=0
Spark plugs look a lot better. One on the left are my plugs from the old ECM...
Trying to run closed loop.
The only place I noticed any knock counts was when I shut the car off, to flash the new .bin after some learnin'. I didn't catch any knock other than that, I'm watching the log over again though. Even at startup, my Caspers knock sensor never went off. Not sure if...
https://www.dropbox.com/s/n8crj2itk5t06vq/2.dat?dl=0
Grabbed one quick before I left, the German Sheps aren't eager for the vets anyways ;)
BLMs are getting better. Knock seems to be there on start up, or when it goes into Closed loop idle.
Thanks guys! Be back in a bit.
Adjusted the IAC a little more, and it started learning. I was recording a log, but windows updates figured it was more important and rebooted my laptop. -_-
It was the CTS preventing it from VE learns. When the fans turned on, it started.
Have to bring the dog to vets, then Ill try to post...
I traded a 71 Camaro for this car when I was in Iraq. My twin was cursing me because the wiring was a train wreck. Probably took a few years off his life stressing :D
I've tried doing BLM VE Learns at idle. Never seems to make any corrections....I'm going out to mess more with the IAC and...
https://www.dropbox.com/s/8p312r7g1zpcilq/10.dat?dl=0
Adjusted them. After holding RPMs higher than idle for a few moments the counts went back down to 16. Ill mess with them more tomorrow. For some reason I really suck at adjusting the IAC.
https://www.dropbox.com/s/e7eul2teoj3bijo/EBL_F_SFI6ClosedLoop_00002.bin?dl=0
https://www.dropbox.com/s/xmjuufdxydxxpcm/First.dat?dl=0
I'm back :)
I was stupid when I wired it up, and had Injector 5 where it shouldn't go...
Moved IAT to Plenum
and rewired the MAPs.
Idles awesome now. But my...