Recent content by edfiero

Is there anything special about that Turbo? Trying to understand the pricing.

Take this with a grain of salt, but lets assume the sensor can read faster than the stock one. Just because it can, doesn't mean that our 40 year old ECU can take advantage of that. Maybe if you also replaced the computer with something from the last 15 yeas maybe you might notice a difference.

Did you get her started yet?

Since you have already replaced the crank sensor..... It might be time to try to get your hands on another ECU. Borrow one to at least rule this out. After 40 years, these things do go bad, and would certainly explain the no start.

10 year old thread, but I have the same question..... Anyone make the Molded seat foam for the back of a Regal or any G-body ? I checked Classic Industries and all I can find there is a Generic foam pad....not molded like the original.

The Ebay page lists this as for 86 and 87. Will it work on Hot Air cars too??

It is the OE tank as far as I know. It looks old.

Vent line is on Yes. But even if not, wouldn't it just vent to air rather than to the canister ?? How do I check for Open?

I recently dropped the gas tank to replace a dead fuel pump. The new pump is working fine, and the car runs good. However I've discovered that its still very difficult to fill the tank. The gas has to be put in very slowly or the pump kicks off, or it splatter back out of the filler hole...

Big Dawg, ever track down the source of your knock retard?

Thanks! Payment Sent.

I am looking for the bumper parts shown in the below picture. Must be in good condition.

So what is the best bang for the buck to improve the handling on the GN? Not looking to race or autocross, just want the car to handle a little LESS like something that is 35 years old. I tried doing a search on Hotchkis to see what of people thought of their front control arms and springs...

Thanks Piratejack. Exactly what I needed. (Meant to say Kirban's website above. Had a brain fart)

My hydroboost unit is leaking. I guess it needs to be removed from the car and get the internal seals, o-rings, and/or gaskets replaced. I checked Rockauto and also Rodney's website, and could not find anything listed. Does anyone have a source and part numbers for what I need to fix up the...