Recent content by Dale G

Thanks for the tip

Thanks for the reply, you are correct I was out for a cruise.

Hi Looking for some input with the attached data log. Once the trans goes into 4th a couple seconds later my tcc box gets checked on the power logger that its engaged, but I don't see the rpm drop after the initial drop once it goes into 4th. Was the tcc activated with the shift into 4th so...

Forgot to mention it is a stock turbo with the boost set for the chip.

Thanks Eric. I'm using a rail mounted fp gauge which I no is a big mistake. I do have it set for 43, but it must be actually lower then 43psi because I was getting knock at the end of 1st gear before the shift.

Before the heads were installed I wasn't getting any noise ?

Sorry I missed some of the other posts. I put fp to 43psi but was gettin some knock so I upped fuel to 150 across all gears. I will turn fp up and reduce fuel in the cell, but I am just learning the new chip configuration. I just don't get why the 02s dipped and later on I got all the noise...

Hi, running no alky,is the noise something to be worried about?. I swapped another mass air with the same noise. Can you also tell me why my 02s dipped so low once I started the run ? Thanks again

I don't think the original attachment worked, I'll try again with this one, Sorry.

Hi Can someone please have a look at the attached log, My mass air and o2 readings seam out to lunch. Just got done having new ported heads and springs installed with a matching turbotweek chip with 60# matching injectors and a factory mass air sensor, I swapped out the mass air with a spare...

Thanks to you guys. Appreciate your knowledge. Have a great weekend.

Thanks. Can u please explain why 1 valve has the grove and the other doesn't. The heads are getting ported now. Thanks for all replies

Hi. I have a couple OE exhaust valves that have wear grove just st below where the keeper sits. Is this normal. I have a used set that has 4 out of the 6 with this grove. Is it OK to use these ?

Hi, valve job is also getting done, I'm waiting on retainers so we can install the springs.

Hi, I bought a set of stock heads that are being ported by a friend. I bought comp cams 981 springs and valve seals for the intake valves.. Do I need shims ?. Thanks