Recent content by cj92345

  1. C

    GN wheels, new T/A tires, caps and lug nuts.....$850.00

    these came off my 86, so-cal car, tires are about 6mo old and maybe have 200 miles on them, I went with race stars, really don't want to ship, hopefully someone somewhat local can use them. thanks.....ph 7604031860
  2. C

    buick meet

    Pretty good deal, I took GS though, some really nice cars
  3. C

    David Spade with his GN on Jay Leno's Garage this Wed..

    car looks a little rough
  4. C

    Knock / Rattle after valve spring replacement uggh

    broken new spring?
  5. C

    Map of CA. owners ?

    hesperia
  6. C

    Buicks @ Bates 2016 - Official Kickoff Thread

    I've been him-hawing about going because of the so-cal heat, but if you az guys are going I sure as hell am going to make the 90 mile drive.
  7. C

    OFFICIAL: wheel/tire picture thread... show em off!

    dark stars 15x3.5 and 15x8 4.5bs 275 60's that will barely rub the left fender molding in sharp driveway
  8. C

    Powermaster to vacumm brake conversion

    mine went also no problem, I didn't even bleed the brakes
  9. C

    Buicks @ Bates 2016 - Official Kickoff Thread

    plan on going, haven't been in at least 10yrs, hopefully GN will be ready for maiden voyage
  10. C

    vacuum brake conv?

    I don't notice a difference, but....I drive like grand ma Moses, I haven't tried launching under boost or anything like that, just normal driving
  11. C

    vacuum brake conv?

    I was lazy and bought a kit, works good, I think it was $330.00, probably a lot but no hassle
  12. C

    Carb/Turbo Bandit Trans Am sells for $110k

    biggest p.o.s 's ever
  13. C

    Wire harness issue after vacuum brake conversion

    Harness is sitting on top of the shift linkage and can barely get it into park, key won't turn to start position in park.....tried pulling some slack in harness but it's bango tight...harness is not piched between booster and firewall ?????? Thanks in advance
  14. C

    Grand national with door trim?

    Working at a Buick dealer back then, we had a molding guy come in every Wednesday, he would do riveted and stick on and tape pin striping, he would do 20-30 cars, mostly run of the mill regals and cutlass's, some GN's
Top