Is there a trick to removing the tilt stalk/lever? I'm trying to replace mine and have a heck of time getting the old one out. I thought they just screwed out.
Looking for the floor brace bracket that goes on the underside of the floor pan. It holds the brace that runs just behind the transmission from one pan to the other. See pics. These are spot welded on the pan, but mine was too far gone to save when I redid the floor.
I have a question on the UMI rear shock brace. Anyone install one of these and use the factory exhause hangers that boot to the spring bucket? I have the brace in, bit the brace is in the way of the hangers. My thought is to use some sort of spacer so I can still use the hangers. Plane on...
August 8/20/16. So the entire suspension is done and brakes almost done. Went with SSBC instead of Wilwood on the brakes. List of items done
1. Front upper and lower A arms blasted, powdercoated, and new ball joints put in.
2, New springs
3. New shocks
4. Blasted and powdercoated front brace...
I just got the body back on the frame after having the driver side pan replaced. I had the entire bottom of the car sprayed with Line-X and wanted opinions on the options above for the inside floor. So far I have sprayed epoxy primer on the floor, both trunk and cabin.
I like the lizard...
So a few months back I was in the process of looking for a GN to build. I figured 40K and 2-3 years of time on this project. In October I found what I was looking for in TN. T-top car with a digital dash. It ran good (oil leaks the main issue) and everything was there. So I tore it down to...
Anyone know where I can get a complete new E-brake assembly? I need the cable from the pedal and to both brake drums.
Thanks in advance for the help and info.
The Captain