Recent content by camino70

  1. C

    Injector/Chip advice

    RL, I am not sure what exactly caused them to fail. I had some rubber fuel line fail, lots of garbage in the injector baskets, so I took them to Chuck Leeper. He cleaned them, some leaked, some didn't operate as expected (stopped completely at different pulses) and the flow rates of the rest...
  2. C

    Injector/Chip advice

    I have been running 50 lb/hr injectors with the Translator Plus with Extender Chip. The 50's died, do I replace them with 50's or do I upgrade to 60's? If I go with 60's do I get the Extreme Chip or TurboTweak? TIA, Ron
  3. C

    Chips for sale

    I also have an Extender chip for 50 lbs. Ron
  4. C

    Chips for sale

    I have a few chips I would like to sell: 009 - PTE Street 93, 20* 16-17PSI - $25 shipped. 2 Red Armstrong chips I need help deciphering. 2 ATR/Pitbull chips I am assuming are worthless, are they even worth the chip and holder? Are 009's with unknown mileage and years old just sitting...
  5. C

    High Flow Catalytic Converter and Test Pipe

    Hi Matt, It is available. Ron
  6. C

    Stock Throttle Body and Plenum

    Stock throttle body and plenum from an '87, $65 shipped obo. Ron
  7. C

    High Flow Catalytic Converter and Test Pipe

    The Test pipe is sold. Thanks! Ron
  8. C

    High Flow Catalytic Converter and Test Pipe

    Any feedback on the prices? Offers? Ron
  9. C

    High Flow Catalytic Converter and Test Pipe

    Sorry for the late response. Both are 14 1/4" long. The Cat is used, but is very close to perfectly round with few imperfections.
  10. C

    High Flow Catalytic Converter and Test Pipe

    Used stainless 3" with 4 bolt flange high flow catalytic converter $100 shipped. Never used stainless 3" with 4 bolt flange test pipe $50 shipped. I got both when I purchase my THDP. camino70@gmail.com Ron
  11. C

    Atlanta Emissions

    Does anyone do emissions testing in the Atlanta area?
  12. C

    Blown Head Gasket

    I only made two runs. About 20lbs and zero knock, 750 mv for the first run and about 21lbs and 715mv second. I kept an eye on the scanmaster and saw .7 and .9 and didn't feel anything. As I turned off I noticed it miss and shut her down. Recall showed 13 KR and 715mv.
  13. C

    Blown Head Gasket

    After looking over it again, it looks like some material is lost at the thinnest section on #6. That is the plug that looked less like the others too.
  14. C

    Blown Head Gasket

    Here are two pics. One is last time I blew it, but it was #3 and the other is less mangled and #4.
  15. C

    Blown Head Gasket

    I blew a head gasket at the track the other day and just got around to pulling the heads, actually only pulled one so far. On the gasket, #4 is not flat like the rest and has a different appearance then the rest, it is a gm. It is not mangled like my last one. Does this constitute being blown...
See more
Top