Recent content by boostified

  1. B

    Factory GN front bucket seats

    Nobody has anything?
  2. B

    Factory GN front bucket seats

    Looking for a pair of bucket seats for my GN. Condition of the covers not important. Looking for useable frames and foam. Need to be complete with grey trim pcs. Will pay for nice ones too. Closer to northern Indiana the better. Thanks.
  3. B

    Fast classic. Gnx dash pte turbo kenne bell upper Tb Gn 1spacer

    I'm just curious what all is involved in running the classic fast ecm ? Never used one, but would like to upgrade. Is it hard to tune? Does it include the software for it?
  4. B

    G body a/c delete panel holds ls computer

    And I'm pretty sure this will fit a Malibu. I cannot say for certain, but it has been my understanding that all the gbody cars share the same firewall
  5. B

    G body a/c delete panel holds ls computer

    I could make plain , flat aluminum ones for $65, without powder coat.
  6. B

    G body a/c delete panel holds ls computer

  7. B

    G body a/c delete panel holds ls computer

    I will post some more pics in a few.
  8. B

    G body a/c delete panel holds ls computer

    Offers ?
  9. B

    G body a/c delete panel holds ls computer

    This is a panel I fabricated for my GN. It holds an ls computer securely in place. It is made out of 6061 aluminum, .090" thick. The cover is held in place with 6mm screws, into threaded rivet nuts. Powder coated black. Foam seal already glued on back. Only selling cause I switched to Holley...
  10. B

    G body a/c delete panel holds ls computer

    This is a panel I fabricated for my GN. It holds an ls computer securely in place. It is made out of 6061 aluminum, .090" thick. The cover is held in place with 6mm screws, into threaded rivet nuts. Powder coated black. Foam seal already glued on back. Only selling cause I switched to Holley...
  11. B

    GN 5.7 LS1 turbo build

    Thanks. I used the aluminum block to try and keep it as light as possible. It's not much more (if any) than the v6 . I'm only shooting for 675-700 rwhp, so it should be ok
  12. B

    WTB Turbo LS_ Swapped GN

    I am considering selling my 87, t-top gn. 99, ls1, th350. Has about 1000 miles on motor and trans. Tuned for 6psi right now. Going to tune for 12, this weekend. Price would have to be right around 45k. Much more invested. Has full, -10 aeromotive fuel system, full autometer gauges, corbeau...
  13. B

    Ls1 turbo breather question

    Seems to work very well. No more smoking issues.
  14. B

    Ls1 turbo breather question

    Then a 3/4 by 1" pex reducer, to a 3/4" section of hose, another t , to the front cover vent tube, then up to catch can.
  15. B

    Ls1 turbo breather question

    Then I bought a 3/4 by 3/4 elbow, for pex tube, attached a section of 5/8 hose to it, and around back of fuel rails, to pass side. Put a 3/4 by 1/2" t fitting to rear valve cover vent tube.
See more
Top