How do you set up the OD clutch pack?

[Blown&Injected]

The ASTG says:

steel...friction...steel...steel...friction...backing plate.


The way it was done in my trans was:

steel...friction...steel...friction...steel...backing plate on the steel.

Now, what it the preferred procedure?

TIA,

 

[blackplague]

The way it should be stock is

The was astg says, "steel, friction, steel, steel, friction, backing plate.

If you want to spice things up a bit, you could take off .070 from the o/d piston, get 1 extra od friction and the stack up would go: Steel, Friction,Steel,Friction,Steel,Friction, Backing plate.

 

[Blown&Injected]

Thanks Mike.

I could still read the print on the frictions that came out of the OD so it seems like it was holding good with the steel - friction - steel - friction - steel - backing plate.

I believe I will do it the steel - friction - steel - steel - friction - backing plate and see how it works.

 

[HOTTOGO]

Originally posted by Blown&Injected
Thanks Mike.

I believe I will do it the steel - friction - steel - steel - friction - backing plate and see how it works.

that is the correct and only way unless you do as blackplague said and add an extra.