Search results

Was wondering if anybody had some good pictures of the driver side header by the firewall, and also the passinger side for sbc in a G body? I just picked up a set of headers off EBay, look like Stainless Works knock offs. On the fence about a sbc in a GN. A link to the headers, OBX RACE Small...

Was wondering if a chain tensioner would be used or not. I installed a roller cam with a stock chain tensioner 2yrs ago, all was fine. Late this summer while getting the car ready to go to the track heard a noise, thought it may have been the belt tensioner bearing, but after belt removal and...

Was wondering if a bolt in roll bar (6 point) would be NHRA legal in our cars?Also, if it is legal, how fast could it go? PLEASE don't tell me 11.50 as I have that setup now ;) THnk's Mike

Have set (6) 50's , and PTE street chip. Injectors were flowed,and marked for each cyl. $275.00 shipped 1" alum. spacer $80.00 shipped

Ok I have these heads with receiver grooves cut in them. OD = 4.240 app. groove width is .060, and the depth of .022 ,figure 8 pattern, (NEVER MEASURED THEM BEFORE THIS WEEKEND). My question is does anybody have an idea what gaskets they might use, O-RING wire and copper? Used 007's befor they...

Wanted, Turbonetics Turbine Housing, T4 series, on center, Q trim, with A/R of .69 or.81 Thank's in advance.

:confused: Wondering what needs to be done to install a TH400, drive line mods and or crossmember mount, any help would be appreciated, thanks.