Search results

Is he going LS? Or did he figure out he would never go 7's?

Well, here we go again!! Bamford's running there mouths ONCE AGAIN!! SHOCKING!!! When will you guys EVER learn?? No one really cares to hear ANYTHING from you! Just because you were lucky enough to be born into money you feel you have the right to run your mouths ALL the time!! That's why...

Anyone ever install manual breakes in their power master equipt GN? Specifically the Wilwood master cylinder? I'm wondering how you hooked it to the factory setup? I was thinking of a heim joint. But I can't seem to find one that will work?? Thanks!!!

In search of a complete set of NOS GN side moldings! If not NOS, must be in perfect condition! Thanks - Greg

Would like to buy a known good GM MAF sensor for 86/86 GN/TR. Must be in excellent shape! Meaning no visible scratches. This will be a spare for my 20,000 mile car! Maybe wiling to buy an NOS MAF (most be in GM box) if the price is resonable. Please send PM's!

Car must have gray interior, have excellent paint, have t-tops or moon roof and be totally rust free!

Precision 76 GTQ turbo (non ball Bearing) compressor side polished / exhaust side silver coated - $1100 (Payed $1350 + polishing and coating) - TA s/s headers (3-bolt) silver coated - $800 (payed $1025 + coating) - Champion on center intake with fuel rails and 70mm upper - $600 (payed $800) -...

Must be in GM wrapper. Must be able to read part number. Must have pics.

Black Right Rear (passengers side) Wheel Whell Molding. Must be in GM wrapper. Must have pics that show it in the GM wrapper, with part number showing. Thanks - Greg

Must be NOS, or a perfect stock piece. It would be OK if a stock piece just needed to be stripped and painted (no dents, bends, or scratches). Thanks

Must be NOS, very nice stock, or nicely redone pieces.

Must have GM box!

Must have a very nice to mint gray interior. Undercarriage (floor pan) must be rust free. Exterior must be presentable. Could be a car that needs paint, just not a rusted up, scrtached up, dinged up mess. I am looking for a car to turn into a race car. Will pay good money for the right roller.

Looking for a really nice set of factory headers. No dents, no welds (can have small welds if tastefully done), all factory heat sleilds must be in place, all four crossover bolt inserts must be in working order (not stripped/drilled out). If you have the crossover that's fine, but I don't...

I am looking for a roller to put my stage II motor in. I will only purchase a roller that my motor and trans can be dropped in, and look very respectful. The interior must be in excellent condition, and gray. Price is open, depending on what you have. Please send Private Messages only, as I...

Would like to buy a stock set of exhaust manifolds in very good condition. Must have the orginal heat shields, no dents, or cracks. Thanks - Greg

I had a complete set of engine bolts for my GN chromed. I thought I had another complete set. However, I have lost the upper engine bolts. I need all the bolts for the upper part of the motor (vacuum block/tps/fuel rail/upper intake/coil pack/studs/nuts/ect.) They need to be in very good...

I am looking for a complete set of bolts/studs/nuts for the upper part of a 86/87 TB motor. I had all my bolts chromed several years back, had a second set, but some how lost them? The bolts must be in good shape (not rusted to hell and stripped). I need all the bolts (vacuum block/tps/fuel...

Does anyone have any positive or negative feedback about TA headers?

Has anyone heard any pros or cons about TA headers?? I am trying to decide which headers to use, given todays very slim choices!