Search results

I have found the diagram on a few sites but its very low resolution unable to see any detail. Anyone have a link to one that's readable? Thanks for any HELP!

I give up!!!!!! I need someone to help me fix this thing! Is anyone close to Alabama that would help me? Or a shop that knows GN's. I am not a dummy when it comes to cars but I am losing the rest of my hair with this thing!!!! Things that I have done to the car. Mods: 60lbs INJ chip to match...

I have a power logger order what senors do I need to get the most out of it?

Thank you for the help!

UR5 NGK .32 Thanks for the help!

I am not sure I understand. Should the fuel pressure rise? Not sure why it would rise. But I am a noob on these cars. please tell me what you mean by 1:1.. I have a new 340 fuel pump and hot wire kit I put on the car just a few weeks back.

Okay I will try that it has a new dense o2 in it though

I have not. Question if I unplugged it while it was running (batch fire mode) it shouldn't still have a problem should it if it was can sensor? I don't know for sure?

Will check thanks!

Please let me know what you come up with on yours and I will do the same. I am going to check the cam today. I was told that it may be wiped. But I hope that's not the case.

I have put on a new crank sensor and have it adjusted. Also checked the balancer

Sometimes it will clear up if I stay in it.

Yes 42lbs

They were standard motor products. Which was recomend if you can't get GM. The capers test tool wont work on non gm module will they? The plugs look good like they are firing hot

Yep!

I wished I knew I have put new coil pack ignition module plugs and wires.

Trying to rule out if I have a bad cam sensor. I unplugged it after car was running and I still have the same problem. Car stars cutting out when it starts building boost.

I put new lt1 maf and translator on it

No the car had some issues it run okay but not good.

Changed out the ignition module thought that was going to fix my problem the old one was about half melted. Still have same issue checked the plugs they looked good clean burn maybe a bit lean. Went over my vacuum lines too. I didn't check cam I really hope its not the cam. That maybe more of a...