Search results

3 Inch inlet and outlet, polished, bar plate. Had one like this on my GN. Never used new in box. 165.00 email or call craig at 702-499-0950 located in georgetown colorado.

109 block with caps. never bored. came out of my gn when i went to a girdled motor. $350.00 located in georgetown colorado. whoosh1986@yahoo.com Thanks craig

kenne bell. 75.00 shipped

magnecore 10mm wire new in box 100.00 shipped

kenny bell 75.00 shipped

here ya go

see below

new crank sensor with bracket and bolt 25.00 shipped obo new cam sensor whole unit 150.00 shipped obo

very low mile turbo pe 64 big shaft. will fit a stock mounting bracket. rated@700+hp, 550.00 shipped. intake plenum hat stock no porting done. 10mm magnecore wires new in box 90.00 shipped

te64 /t64e big shaft turbo 700+hp, 1000 miles couple runs 575.00 shipped

hrpartsnstuff poly mount 75.00 shipped water pump pulley 25.00 shipped 55lbs injectors 75.00 shipped blue kenny bell fuel pressure regulator 85.00 shipped (looks like acufab but blue)

injector harness, 25.00 shipped nos antena make offer nos piller trim make offer nos rear end cover gasket make offer

2nd owner, Nevada car have owned since 95' i believe there is 102k on the odometer but i havent looked at it in a long time. rust free, new paint, mostly all stock, alum inner bumpers and brake drums, hardtop, analog dash, trunk release, ac, pw windows, seats and locks, remote mirror, factory...

turbo motor from valve covers to pan. less than 1000 miles and 10 passes $2700. obo pick it up in las vegas turbo 109 block 30 over trw forged 8.6 pistons polished rods 10/10 turbo crank d roller chain rjc girdle comp billet roller setup 213/213 ported polished iron heads w T&D roller rockers...