Search results

Are there anymore of these types of buicks rolling around or race? Drag racing is by far my favorite type of racing but Its nice to see a buick running a race with a few bends in the road. Anybody running any road race or time attack set ups?

I got it out thanks. WD-40 and a hammer. Bent easy but the new one is alot thicker. Now i have a stuck thermostat. I believe that is the source of my overheating problem.

<iframe width="420" height="315" src="http://www.youtube.com/embed/34WsOL_VlKQ" frameborder="0" allowfullscreen></iframe> I love the aero kit on this car…looks very aggressive. 2000 Lime Rock Vintage Festival Group 7 Race - IMSA GT/Trans Am/NASCAR - YouTube

Any ideas on how to remove a stuck thermostat housing?

If it ain't one thing its another. Went in to change the thermostat and found the thermostat housing rusted to **** with an even rustier thermosta. Just ordered a new housing from autozone and am trying to locate a stainless steel one for the next time I pull it off. I still havent flush the...

Car ran good. Changed heater core but still got a leaking problem,not sure of where but think its a hose or something in the line of the radiator. We seen smoking and steam evaporating along with burning water fumes. We pressure tested the radiator cap and it wouldn't hold any pressure. We...

RED C5: What kind of radiator is it?

Just rented a pressure tester from auto zone for 75$. Also just ordered the 160 degree thermostat and purchased a duralast water pump. Thermostat wont be here until tommorw after 3pm so I got to wait another day. Looking at the heater core what am I looking for? I figure thats something I can do...

Im going to pull the carpet on the passenger side to check to see if its moist. I have not pressure tested the system, you can fine a pressure tester at autozone for cheap correct? Im going to pull off the cover cover to the heater core and check what I see. Im going to buy a thermostat today...

Got a 87 GN. 133,000 miles. Took it out for a lil spin after sitting for 7 months and I noticed smoke coming from the passenger side a/c vents and the center console by the ashtray.You could hear the sound of bubbling coolant along with a slight knock in the engine. After pulling over I noticed...

How bad is the rust? Scale of 1-10. How much shipped to 93245?

Will these fit on a stock 87GN? Stock cam?

Now is this for just the turbo only with hd actuator? Is it a ported shroud?

Whats the big difference in the 6262 and the 6265. And is the journal bearing spool that noticeable compared to a DBB? Im still running a stock converter so Im gonna buy a 6262 and wait until I can afford the converter then install them together.

Whats the cost to have a shop change your valve springs and timing chain? I don't think Im up for that big of a project yet Im still learning.

AZ3 humphrey checking in, 4 years this March. 87 GN in progress slowly but surely.

Just what I been looking for, Tell me you got an actuator thats goes along with it?

pics?

King money banks and POWERSIX. Is this the ported 4 inch inlet you have? Im looking for either one of these?

Aftermarket bigger is better in the cooling DEPT.