Search results

Hi to all I have a 79 cutlass with a metric 200 not a 200r4,no reverse. Yes is those old cheap trans,but runs fine forward. Can it be a seal gone bad? Thanks.

I had these parts as spares. Crankposition sensor $40, Cross over pipe $30, and Stock AC Delco replacement fuel pump $30

I had these parts as spares.I don't need them. Cross over pipe $30, TPS voltage inhancer $25, Stock repacement AC delco fuel pump $35, Crank position sensor $40 ,Free stock MAF no screen on it. I had these parts as spares.I don't need them. Cross over pipe $30, TPS voltage inhancer $25, Stock...

Is any body using juice on a hotair? If so what kit is it, dry or wet? 75/100 or 150 shot? Do you like it? How fast are you going with and without juice? Thanks.

I have a used in very good condition kenne bell boost a pump complete kit.same as this . Kenne Bell Boost-A-Pump I have pics can email.

grey carpet o.k condition, prefer 84/85 but 86/87 is o.k.

Hi to all,this is an 84 wh1 that some one aboarted and I saved from the scrap yard in 2007.The engine was blown in the trunk and half there,the other half of the parts I bought here and there. I rebuild the Engine40 over rings,rod and main bearings clevite77,edelbrock cam,lifters,and double...

For the n/a guys, I have a set of 6 allmost new 5,000 miles 40 over n/a fed mongal pistons and turbo 2 dot rods for sale 70$ plus shippng.

Very intresting the stock intake flow #s http://www.turbobuick.com/forums/engine-tech/363911-interesting-numbers.html#post2900635

Need a gas tank.

Can you use a n/a regal gas tank ? Thanks.:confused:

Hi to all,Do I still use the posi rear additive even if I do not have the clutch type posi unit? I have the auburn type with the springs.Thanks

Hi to all! Ok here is my senerio,when I part throtle my car the car thrust foward pretty good.But when I wot the car it winds and it feels like the boost is behind the power band. The engine has less than 5k:confused:

Almost new 4,000 miles n/a 40 over fed mongal pistons and stock turbo rods $80.00. Cost me $60.00 just to press the pistons on rods.

Hi to all! To those that have the egr deleted,are there any performance gains? How did you do it,just plug up everything? Thanks.

Hi to all. How Do you guy's get an accurate imprint to port the intake and heads to match perfect? Thanks.

Hi to all! How far down in the hole doe's the piston sit from the deck on a stock 86 block? What is CR? Thanks.

Hi to all,Where can I get a stock turbo piston 40 over.

Hi to all,I'm looking for a stock turbo piston 40 over. Thanks.

HI to all ! Is anybody using the shim copper head gasket? Are they any good?