Search results

i have a 3000 art carr lock up that looks JUST like yours, i would say an old art carr

my 61 has been a good street setup, you should like it

also check your intercooler hoses and clamps

sorry i did not take time to read the post above:D air filter clean? could the stock flex tube be colasping under boost? is your car still running good? any oil in the intercooler (bad bearings-seals) is the impeller easy to turn? maybe this helps..

take your rjc controller apart and strech the spring A LITTLE BIT, watch out for the ball bearing it side!! mine did the same thing a while back. WATCH THE BOOST ON YOUR FRIST RUN!!!!

is the a/c and heat working?? would it make the trip from Ohio to myrtle beach S.C. ?? thanks:cool:

count me in also... money sent:)

pix. sent :)

i,ve got a 86' t-top ,, i.m the 2 ed owner with 56k on it,, it's not perfet but runs very good and it was bone stock when i bought it from the org. owner,, every thing in the sig. i've done my self.. i've only got about 700 mi on the new 61bb turbo,,, i drive it every day with my 4 girls so i...

help???? :(

just yesterday my a/c is working good and then my a/c duct system goes into defalt defrost mode, i know that that system is vacuum operated. is there a good place to start to look for a leak? thanks for the help,,Terry :)

Jack Cotton sells a nice 61 bb turbo that does not use water to cool it,, and i ran this turbo with my stock d5 for afew weeks and it did good on the street.. but i would HIGHLY recommend some type of stall converter with ANY turbo, even the stock turbo could use a little more stall,, if you...

brian, i got in and cleaned the tps connector and she's running like a dream,, thanks for the help!!!! :) Terry and yes-- it IS time for some type of scan tool, i think i've gone as far as i can in my tuning without knowing what is really going on :redface:

sorry Brian, i don't have a scan tool :rolleyes: , but no codes are comming up .. i do have a tps-tec throttle enhancer that showes the green light at idle so the tps should be set right..

hi guys,, my car will stall after a quick stab on the gas, after about 3500 rpm. it will do this driving down the road or sitting still in the parking lot,, if i rev it quick past about 3000-3500 and snap the throttle shut it will stall, and the samething will happen on the road?? this has just...

thanks Eric, i'll work on that tomorrow, it seemed best at about 45-47 psi,, but i did not cut back any alky.. thanks Terry :)

thanks Lee,, i'll try it :)

guys,, where should i set my fuel psi?? i'm running 031 42.5 lbs injectors with a tt alky chip?? the lower i set the psi the slower my throttel responce is,but seems to pull good on top end.. the higher the psi, my throttle responce is much better but seems to pull less on top i'm running 40...

it your intake pipe long enough for an intergrated turbo (turbo with out the bolt on inlet bell) also does it have the hoses,, thanks Terry

exhaust it is!! where should i go?? cottons?? seturbo?? jay's?? and also i see a lot of you guys running a single system?? is this just for weight? what do you think.. thanks Terry :)