Search results

Ok OK thanks, I only need the side pieces, my lid and other pieces are fine, if you have a parted out one that would be great, otherwise just e-mail me what you have. Thanks!

I'm not sure if you can help me or not, I'm assuming you have lots of misc parts. For the center console of a 87 WE4(all grey) the plastic down the sides near the RH side of the shifter is broken. Do you have any consoles? or possibly that piece of plastic??

email wileecoyotemoore@verizon.net

dash bezels need dash bezel email me

ttt ttt

Ok Email me with how much and where to send the money too. I was going to sandblast and repaint them anyhow, just want some done before I take mine off.

still You still have them?

reply MAP, I've read many of your posts and noticed you seem to know quite a bit about the theory and principles of suspension movement and allowable tension. In all your research and discussions on the boards, what is your conclusion for the best setups?? It would be great if you could give us...

arms Did you take pice of the boxed arms? Or better yet, while you were doing it? Would be great to see!

arms would like the rear arms, do you do PayPal??

Yep I'm with Dave. Because of the high content of metal in todays pads they are coated pretty heavily with a film to prevent rusting. This will at times prevent the pads from setting in initially and sometimes you need to make some "aggressive" stops to burn it off. Sounds like you have already...

Cursed? Is this thing cursed or something? I'm looking around at different combos and the 45 seems to fit lots of combos, but this thing has been through 3 people and only the original owner even bolted it on?

DickDiverter? I think my old lady owns one of those!!

Pm PM sent, I sent email, no reply yet.

shaft The shaft is not supposed to be collapsed like that, Does it have signs that it's been dropped? The reason it's like that is they usually inject plastic in that slip joint and the only reason it's there is so that in case of a front end collision the column will collapse instead of drive...

sorry I'll be gone for a while, would have done it just crazy schedule. Thanks again, check should be there by wed.

where are you By the way, I see your in VA, where?? Maybe I can pick it up, I'm in Southern MD

bezels If you have another set, I'll take em, these are what I wanted

pics Can you post a pic of the chip on the drivers side marker

Sway bar end length Not to hijack your thread Squid, but if you install the 1" drop springs(eibach) What is the difference to need to subtract for the shorter distance between the lower arm and the bar mounting location on the body? The drop is 1" at the ball joint, but what about at the arm...