Recent content by viokrome

$295000.00

Iam off of old brownsville rd. towards bartlett.

I have a 87 gn, the brake light comes on when i press brakes for about a second then goes off, I tried to dpresserize the system with key off 10 pumps then key on the motor runs about 12 seconds. Still get light when brakes are applied. So should I replace the accumulator ball (still original)...

I live in Arlington also, dont know a mechanic around here as I do all my own work. What do you need I might be able to steer you in the right direction.

I try to go every chance, I have not driven my car lately because I just replaced the rear main seal. Trying to order a TT chip so I can get back on the road!

Just had the driver side header welded and pressure tested,also checked the r/h header also it was good, the stock boost guage is close checked it against a after market one and it was close. Going to install a autometer pro comp boost guage next week to be sure. From what I have read the...

I have an email in to eric waiting to hear back so I can figure out what chip injector combo to run, the lowest chip injector combo the have listed is for 42 lb. injectors. Any suggestions would be great! Thanks.

I think I finally found the problem! I was told the car had a stock ecm chip but after further inspection I found a hypertech 41372 Installed. From what I have been reading this could be what is causing all my problems, cold start surge, rough idle,over boost and detnation at wot. Still dont...

After looking around I found that if i shaked the exhaust that the l/h tail pipe was hitting the gas tank with not much effort, so I adjusted it now it does not hit. Also was told to roll into third gear and check readings that shifting hard could cause false knock. I will drive it and report...

Original wastegate actuator. The previous owner insalled the hose. I think I might have a vac leak at the throttle body to plenum will check again.Going to install a after market boost gauge. Will double check the exhaust for anything touching but I dont think so. Thanks...

O.K. here are the numbers! I was lucky to have a local TR guy ride along with me to check it out. The car cold started and ran fine at idle start-up for the first time I cant explain it? I took it easy at first to check the rear main seal, all good no leaks! But when I did a few WOT runs my...

Those are all the mods done to car, all original except the mods listed and a fuel pressure gauge on the fuel rail, gaskets and seals!

Will get some good scanmaster numbers tonight when I go for a drive, just replaced the rear main seal need some miles for a leak check.

Cold engine start surge and cutoff? I have been looking for a answer for what could cause this on a completely stock engine with all scanmaster readings correct. I have heared of going with a ls1-lt1 maf and translator will fix the issue and that a modern tt chip and injectors can fix it. I am...

I would like a set if a deal falls through!