Recent content by Tom Willard

Thanks Craig. At least I have some glimmer of hope! I've never been to MI. I'm not the same guy. Thanks for all the replies. I feel like an idiot for doing that!

Geez, I CANNOT believe I did that! I've got my fingers crossed

Installing FAST. Got all wires run where they need to be. Buick interface harness (Fast Track) all hooked up. While running the O2 wires I taped the 7 wire ends together so they would go through body of car better(they were removed from weatherpack connector). I decided to move my car back a...

dam nice!

I should have said fuel pump hanger - - Must work and not be cut up

Anyone ever ran one of these gaskets? Any puck sealin problems? I know a small leak there wont hurt anything. I hate that water coming out when I start mine. It gets on my polished dp and makes it look bad

looks good sent you a pm

I'll bet this is for the guys who like to inhale nitrous rather than put it on their vehicle. All packaged as if to work on a vehicle. Sort of like someone selling a bong and calling it a paperweight.

My buddy...I wont mention any names:D was changing the oil in his t type and got in a hurry. Started it after he put the filter on and ran for 15 - 20 seconds before it hit him what he had forgotten. Car runs and sounds fine. Think it hurt anything?

good advice. Let us know, I'm interested

Dude, seriously you need to chill with the anti-SMC kit attitude you keep putting out. jsta6 has a legit question and you poke him in the eye with a cut to the SMC kit. Not only are you anti SMC, but you are also anti pump speed controller from another post. I think you have added some good...

geez... Must you always be on the "negative" when this subject comes up? :rolleyes: Thank goodness TA Performance is continuing development with our cars. How about showing some support or go buy a Honda.

bs look at when he is just getting straightened out from a dead stop. His speedometer says 30. Something stinks here...I think it's the vid!

That is an old school device to adjust pressure with a factory regulator. I don't know who mad them, but I've seen a bunch of 'em. Been a long time tho!

is this the Walbro 340?