Recent content by Stock?

I'm in !!!!!!!!!!!!!!!!!!!!:p

Thanks again justa, got another one when if you get a chance, 02 ford 1FTRW073X2KD27731, thank you !!!!!

carfax please 02 harley truck,# 1FTRWO73X2KD27731 , please send paypal address, Thank You very much!!!!

carfax please need a carfax, please, 00 VW 3VWCC21C9YM494289 Thanks !!! ( I think I bought my mother a lemon)

carfax please Need carfax and your paypal address, 00vw #3vwcc21c9ym494289 THANKS!!!!!!!

I love my 3" dp/ dump combo from Keith, I waited 6 mo. before I traveled 3hrs twice a week to try and catch him at his shop, I got it a mo. after that! Killer fabricator/ welder, but he'll tell you himself, don't pay him first, try going trough a vendor

I have done both, if you choose to chemical strip, make sure you neutralize the acid in the stripper, it will corrode the metal under your primer, you can use a vinegar/water solution, or I like the" metal prep" 2nd step by Dupont, Chem stripping is labor intensive,and messy, now I send the...

No , problem, run that zo6 real 'soft' in the rear, ten speed ran 11.30's w /1.4 60' on f1's just by running the rear susp. loose at the track, not good for the street , but awsome at the track. P.S. just picked up an X-11 69 camaro fact. orange car/ 4spd, any parts kickin around? need...

Gangsterr, I bought your exauhst cut out when you went to the 3" try ebay, don't settle for less, I know what you have in that car,and it's no less than perfect!!! , call me if you need a spot in my shop to store it untill some one jumps on this deal, heck one this clean stock goes for 10-14.5...

You can cut the lip up to the pinch welds/spot welds, not beyond or else the quarter separates from the wheel house, after that, roll the lip flush to the quarter, I used the trim by cutting slits in the flange,then rolling it up to the quarter

Car is in L.I. N.Y., I'll have it by the weekend, I just took it in on trade for a tahoe, I looked at it quick in his garage, doors are clean, just starting a little bit on inside of drivers, small dent in lh quarter, (1.5 hr) I own a body shop, Let me know what you need, how much of a...

Hi, I have an 86 T , Rosewood/grey int, T-top,68k orig, has 87 grille, gn bumpers, and is a turn key car, let me know what your looking for , I need the drivetrain for another project so I'll split it up

Thanks for the info!!!!

Is the 21n a polyester? Do you cover 100-180 scratches w/it? and is $130 for the set-up? If so thats cheap! the speis is 325 for a gallon set up, thats why we're looking for something else, thanks for any input,

does anyone use a polyester primer in their shops? I use the Spies Hecker,but its getting real expensive, just curios what others are using , and who likes what