Recent content by r0b0t c0rpse

I'm in!

IDK about SBC but on a SII 3800 you can remove the check valve from a oil filter, fill it will oil (install it), put a barbed fitting in the oil pressure sensor port with a hose and funnel on it, fill with oil and turn the engine over backwards(by hand, i used a flexplate wrench)... put a quart...

I'll roll on that <entered> ;)

again... you are pushing the gas slowly?

the stock boost gage runs off of the MAP sensor and refreshes quite slowly. It may be that by the time it does start to give you a reading you're already past 3k rpm. Map sensor sends the signal to the PCM which sends the signal to the gage cluster or DIC or where ever the GTP gage is. If...

the oil should be fairly clear and come up the the bottom of the threads of the drain plug.