Recent content by Nesis

Still for sale virgin heads?

Looks nice,you can remove the valve cover without being removed from the headers?

Grooves is correct place (.120) with my setup and that true what Ttype6 said KB washers is not available only if you find parts wanted market place.

Need a new snap ring grooves because the shaft ends of the rockers are not aligned properly on the valve stem. the shaft does not stretch ..... easily ;). I bought different thicknesses of steel shims but lockable KB washers make work easier. drilling must be done carefully that there will be...

I have driven race season 2015 in this setup ... TA stands / TA rockers / GN1 heads/109 ... I checked the installation before installing the valve covers. the push rod hole was just so big that the push rod does not hit ... I did not take pictures of the installation last winter, but when I...

What would you like to know more? I can take more pictures tomorrow .. I used the old Kenne Bell lock rings, as shown in the picture.

I drilled holes , 3 holes / head (13.5mm) and a push rod does not hit holes.

Yes there were two racing car (109) for two seasons and have not had any problems or cracks ..... we make headers stock, T4 or T6 flange...single or twin scroll..

I did a little machining work for rocker shaft and shimming ... GN1 heads / TA rocker stand .... now work fine..

Here are a couple pictures 016 rear main seal.

still sale?

For sale TB injector driver and resistor set (3 full set +reserve a few) MC 3484. $ 420 + shipping. Paypal works.....

Syvecs s6 work fine and adjustments and settings are beginning to be in the area.....:) My Buick best is 9.93/136(best mph 139) and (convert slip about 25%) now converter is repaired and JP:s Buick best is 10.8/122 . This is good point go ahead and next weekend in Finlands drag race series...

First a nine .....left list...:cool: and the second a nine....:D

A tiny winter cruising.... the weather is nice in Finland. -16 celsius :cool: